Joining Steel Brake Pipes

There are three main methods of joining pipes together and attaching fittings to them.

Joining steel brake pipes.

And he said no problem with joining the. However these pipes can deteriorate to the point where they start to leak causing a dangerous loss of brake fluid and eventually partial or even complete failure of the braking system. Some occasions call for replacing just a section of brake line rather than the entire length. Joining two brake lines together with a new spliced section can be accomplished with a few specialty tools and some basic steps.

No one seems to do steel connectors foe 1 4 inch pipe only brass ones and i am sure that i have been told not to use brass fittings. I have a bit of a prob i need to join two sections of 1 4 brake pipe. Flaring steel brake pipes. Flaremaster joining brake pipes.

Discussion in general land rover forum started by honolulujoe apr 5 2017. I have a corroded steel brake pipe on the car it is only about 50mm at the rear end the rest of the line to the front of the car is sound. My profile my preferences my. Checking the condition of your car s brake pipes is a job that is all too easy to forget because the pipes are mostly hidden underneath the car.

Brake lines suffer impact breakage and corrosion over time and need to be replaced. Some say it is not possible with steel only copper. I have to change the brake pipes on my son s car as they are rusted over the back axle.